Author Topic: Dual Angle drill for high top weight? (Read 1588 times)

Ptownbowler1986 · « **on:** January 21, 2018, 03:39:22 AM »

Just curious if anyone or there has found a good dual angle layout for a ball with a high top weight, I just bought a 900 Global All Night NIB with 4.08oz top weight, if anyone has any ideas please reply or pm me.

Thanks

Gatekeeper · « **Reply #1 on:** January 21, 2018, 06:38:19 AM »

Really need to know the pin to CG length more than anything else. Lots of dual angle drill options especially for that symmetric core. TW of 4 ounces isn't bad; essentially you'll be removing about 3 ounces with drilling.

Impending Doom · « **Reply #2 on:** January 21, 2018, 09:44:50 AM »

How are you planning on drilling it?

rotofan775 · « **Reply #3 on:** January 28, 2018, 01:05:10 AM »

ptownbowler is my new account, finally remembered my old account password.

anyways, pin distance is 5-5 1/2 inches. not quite sure how I'm gonna drill it yet, but definitely want to fit it under my track 607a se. will talk to ball driller probably tuesday. want more for length than anything. not too skid flippy, been a while since i been in the pro shop, so my dual angle knowledge is rusty

ignitebowling · « **Reply #4 on:** January 28, 2018, 07:38:00 AM »

Keep the cg near your center grip line and adjust the pin to your desired pin to pap. If you want a flare increasing weight hole move the cg down and right some (if right handed) so you have some positive side weight and thumb weight for such options.

Then if you need to know what that means for dual angle numbers go add all of the lines and see what you get.

Author Topic: Dual Angle drill for high top weight? (Read 1588 times)

Ptownbowler1986

Dual Angle drill for high top weight?

Gatekeeper

Re: Dual Angle drill for high top weight?

Impending Doom

Re: Dual Angle drill for high top weight?

rotofan775

Re: Dual Angle drill for high top weight?

ignitebowling

Re: Dual Angle drill for high top weight?