Author Topic: Removing a VISE "IT" (Read 1941 times)

LexiusLefay · « **on:** February 18, 2011, 11:41:53 PM »

I just got a ball from Ebay with an "IT" installed. Since no one in my area has this, how do you remove an "IT" installation in a ball? My proshop is old school and hasn't done these before. Thx.

Stan · « **Reply #1 on:** February 19, 2011, 10:43:42 AM »

You can put a thin screw driver between the top sleeve and the ball and carefully pry it out. Then you can use a 1 1/4 drill and drill out the ball-it. Without moving the ball, insert a 1/2 drill bit and drill out the safty molly. Then plug the ball.

Author Topic: Removing a VISE "IT" (Read 1941 times)

LexiusLefay

Removing a VISE "IT"

Stan

Re: Removing a VISE "IT"