win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: P4 Garfield Hole  (Read 2574 times)

2handedrook12

  • Hero Member
  • *****
  • Posts: 1702
  • Be yourself and keep it simple.
P4 Garfield Hole
« on: May 26, 2015, 12:00:37 PM »
I can't remember which core can't use the P4 gradient hole. I am thinking it is a symmetrical core because they don't have a mass bias. I am looking at the options of maximizing a balls hook potential (not back end ).
Logged
League: Pitch Purple, Destiny Magenta
Testing: MVP
Interests: Black Widow, Proof Solid, Idol Pearl

 

Impending Doom

  • Hero Member
  • *****
  • Posts: 6288
Re: P4 Garfield Hole
« Reply #1 on: May 26, 2015, 12:39:50 PM »
LOL@ Garfield hole

DYAC!
Logged

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: P4 Garfield Hole
« Reply #2 on: May 26, 2015, 03:37:50 PM »
You're right, with symmetrical balls the MB ends up very near the thumb hole, so it's impossible to use a P4 hole.  The double thumb layout will probably be what you're looking for.  --  JohnP
Logged

J_w73

  • Hero Member
  • *****
  • Posts: 2540
Re: P4 Garfield Hole
« Reply #3 on: May 26, 2015, 04:26:06 PM »
Any hole 6 3/4 from the pin  in the lower right quadrant of the ball will increase the flare.  Depending where you put the hole will change how the ball responds to friction.   If you are looking for an earlier read and hook then a surface change might be a better choice if the ball will not burn up and roll out from the increased friction.

What ball are you trying to adjust?  What layout is on it now?
Logged
375 RPM, 17-18 MPH, 45+ DEG AXIS ROTATION, 17 DEG TILT

kidlost2000

  • Hero Member
  • *****
  • Posts: 5789
Re: P4 Garfield Hole
« Reply #4 on: May 26, 2015, 05:16:17 PM »
Maximize hook potential.

Lot of ways that can go depending on the ball,  the bowler,  and the lane condition.
Logged
…… you can't  add a physics term to a bowling term and expect it to mean something.

Impending Doom

  • Hero Member
  • *****
  • Posts: 6288
Re: P4 Garfield Hole
« Reply #5 on: May 26, 2015, 05:26:44 PM »
If you're talking max flare for a symmetrical, pin 3 3/8 inches from pap, place cg where a large hole can be placed 6 3/4 inches from pin, 1 1/8 inches by as deep as the drill will go.
Logged
Pages: [1]
« previous next »