Hey all, I just picked up the 2.0, and was wondering if anyone out there has experimented with any cover changes on this ball.  Mine is drilled pin under the ring with the mb about an inch right of the thumb (no weight hole).  My favorite cover change is 500 abralon with polish over it.  Polish gives length through heads, and the 500 gives a strong arc.  Thats usually on pin over bridge drills though.  I play straighter up the outside with good speed and rev rate.  I have a pin over bridge REvolver with the cover at 500 with polish which is great when the lanes break down, but it skids a little to much if there is fresh oil in the heads.  I drilled with mission 2.0 pin down to be a bit stronger than the revolver, but for playing up the outside, even with my speed being around 20mph, it just snaps as soon as it gets to the midlane, going through the nose or brooklyn.  Do you think if I just match the cover change on the revolver that it will give me a similar reaction, just stronger on the backend not being to skid/flippy with the stronger core and layout?