win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Deadly Aim surface change  (Read 2358 times)

12XSECH

  • Sr. Member
  • ****
  • Posts: 379
Deadly Aim surface change
« on: May 11, 2014, 08:14:58 AM »
Anyone change the surface on this ball? If so how did it take to it? I just got it and can use a little more length but it already comes out at 4000.
Logged

 

Jimmy Fields

  • Jr. Member
  • **
  • Posts: 33
Re: Deadly Aim surface change
« Reply #1 on: May 12, 2014, 01:11:19 AM »
I also have one drilled pin up over middle finger cg positive no weighthole sorry i can't give you the numbers. But i also needed more length i was blaming a sore shoulder and dry lanes for the lack of length. This past week i glassed it up and had a better line to the pocket for my straight is great game and a more pronounced flip..   
Logged

Plowboy300

  • Hero Member
  • *****
  • Posts: 544
Re: Deadly Aim surface change
« Reply #2 on: May 12, 2014, 10:19:55 AM »
I would apply Ebonite Factory Finish Polish on the ball... The current surface is Clean & Sheen which is about 1500 grit polish on the ball... the FF polish will give you another 1-2 feet down the lane.

Hope this helps...
Logged
Michael Thompson
Hammer Amateur Staff Member

12XSECH

  • Sr. Member
  • ****
  • Posts: 379
Re: Deadly Aim surface change
« Reply #3 on: May 12, 2014, 04:24:21 PM »
Put that on over the clean and sheen?
Logged

Plowboy300

  • Hero Member
  • *****
  • Posts: 544
Re: Deadly Aim surface change
« Reply #4 on: May 12, 2014, 10:34:07 PM »
Correct.... Just add the FF polish on top...
If too long, then hit it with a 3000 pad, then FF polish.

Logged
Michael Thompson
Hammer Amateur Staff Member
Pages: [1]
« previous next »