BallReviews

General Category => Drilling & Layouts => Topic started by: tuckinfenpin on September 13, 2017, 06:25:33 AM

Title: same layout for asym and sym?
Post by: tuckinfenpin on September 13, 2017, 06:25:33 AM

Lets say for example both balls have the same cover like the hyroad pearl/code black. Will putting the same layout on both balls be suggested? Sorry, but I do not have the dual angle numbers to give. 
I love my hyroad pearl, and have an undrilled code black.

Title: Re: same layout for asym and sym?
Post by: mrwizerd on September 13, 2017, 07:01:17 AM

Good question.  My guess is you are going to get a wide variety of answers.

Title: Re: same layout for asym and sym?
Post by: Impending Doom on September 13, 2017, 08:18:53 AM

The first angle on a symmetrical ball doesn't matter, only thing that matters is if there's an extra hole or not.

Title: Re: same layout for asym and sym?
Post by: Luke Morningwood on September 13, 2017, 11:08:52 AM

Given that you are looking at 2 balls with the same cover stock, but having different cores, drilling them the same would yield different shapes based on the difference in construction between the two cores. They would act differently.
You could do worse.  Surface adjustments would fine tune them to be complimentary.