BallReviews

Equipment Boards => Brunswick => Topic started by: fishbowler on December 22, 2005, 01:58:24 AM

Title: AI Drill Question
Post by: fishbowler on December 22, 2005, 01:58:24 AM
hey I got an AI in a trade.  the pin is right above the ring and the cg is right below the ring.  onlt a 1.5 inch pin.  no wt holes.

I would like it to finish harder.  is there any wt hole that will help me accomplish this with this drilling??  thanks
--------------------
"I'd quit this game if I thought anyone would give a damn!"
Title: Re: AI Drill Question
Post by: MegaMav on December 22, 2005, 10:17:38 AM
if its not finishing hard enough, maybe you're using it on a condition with less oil than it is intended to be used on.
Title: Re: AI Drill Question
Post by: fishbowler on December 22, 2005, 10:27:21 AM
naw, its med oil, but the backend is just so mild arcy that I though if I could get it to "kick" a little more on the end it would be killer.  can shoot a 225 with ease with ball but no higher.  too many corners.
--------------------
"I'd quit this game if I thought anyone would give a damn!"