win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: How to drill my Avalanche Pearl?  (Read 1137 times)

strikestriketapped

  • Hero Member
  • *****
  • Posts: 3372
How to drill my Avalanche Pearl?
« on: April 27, 2008, 12:30:02 PM »
I ordered an Avalanche Pearl with a 3-4" pin and 2.5-3.0 TW. I'm hoping that this ball will fit well under the Twisted Fury, be good for med/light, but have more length. My PAP is 4.5" over and 3/8 up. I was thinking of drilling it 5" from my PAP, pin above the fingers. Would this be a good idea?
Logged

 

strikestriketapped

  • Hero Member
  • *****
  • Posts: 3372
Re: How to drill my Avalanche Pearl?
« Reply #1 on: April 28, 2008, 06:39:13 PM »
ttt
Logged

lilmike2782

  • Hero Member
  • *****
  • Posts: 521
Re: How to drill my Avalanche Pearl?
« Reply #2 on: April 28, 2008, 06:42:49 PM »
pin above the bridge.  that is how mine is drilled and it fits under my twisted that is drilled the same.
--------------------
ultra zone
hammer toxic
twisted fury
hot rod hybrid
kick zone
avalanche pearl
clear golf ball
Logged

John D Davis

  • Hero Member
  • *****
  • Posts: 705
Re: How to drill my Avalanche Pearl?
« Reply #3 on: April 28, 2008, 06:43:43 PM »
This thing goes for days drilled like this... I wouldnt drill it for length such as being 5" from pap because it may not react hardly at all. But, however, if you drilled it real strong then it may compliment the twisted... I have a power groove with the pin under the middle finger and then the P Avalanch like you sugested with the pin above the fingers and they both react very similar, if that helps you any.
Logged

strikestriketapped

  • Hero Member
  • *****
  • Posts: 3372
Re: How to drill my Avalanche Pearl?
« Reply #4 on: April 28, 2008, 07:29:34 PM »
Inverted, I will be placing the pin in the same spot as the Twisted. Thanks.
Logged
Pages: [1]
« previous next »