if you look at my profile i have pictures of layouts.
i have a slug in my absolute inferno, and im getting used to it as its my first slug...
yes yes, i was a thumb slug virgin <blushes>

anyway, i use inserts, and will get a slug if needed to get the bigger drilling hole.

i was under the impression that this ball is non-aggressive
but if top weight has minimal effect on reaction, then im not worried.

Bump, to get nick's attention...

can you answer the above question please?

thanks for the info, but i was looking for an answer to the, "what is the layout on your raven" question.

if you take a look at this layout  ---> Danger Zone Black

the layout i have in mind will end up similar to that, pin in same location, and CG 1" right of grip center.
i measured it all out with a tailor's measuring strip on it.
im money on this layout.
would you recommend it with the raven?

so let me get this straight then, the CG punch is all about where the top weight is?

i was under the impression that top weight was the representation of how much the core is shifted towards the pin on the surface.

apparently not then, what is top weight?

Edited on 11/9/2005 6:33 PM

so you're telling me, even though the CG would be 1" dead right of the center of my grip and the pin in the same location at the danger zone layout, that it wont get back to 1oz side weight?

i thought you said previously that the CG needed to be within 1¼"

yes, it is.

but! i said i was going to but the CG punch 1" dead right of center of grip and put the colored pin in the same location as my danger zone.

Then you should be fine, like I've said.

Toodles.
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-05
¡Viva la nación de Brunswick!