BallReviews

Equipment Boards => Brunswick => Topic started by: strikealot on August 06, 2003, 01:30:19 AM

Title: resurfacing eliminator
Post by: strikealot on August 06, 2003, 01:30:19 AM

has anyone resurfaced an eliminator with any success,if so how. mine got chewed up a little, proshop cleaned it up but doesnt react the same.
--------------------
nothing ventured nothing gained  

Title: Re: resurfacing eliminator
Post by: Strider on August 06, 2003, 04:43:06 PM

quote:

---

sandpaper kills particles

---

Not necessarily so anymore.  I still like to use Scotch Brite to be safe, but most manufactures now say that sandpaper is safe.  I'm not sure if Brunswick even persuades you to use Trizact on their particles anymore.

On Edit:  Here's a link to recent discussion about what the some of the manufacturers recommend to resurface their equipment.  Make sure your preferences are set to at least 14 days to see all the replies.

http://www.ballreviews.com/Forum/Replies.asp?TopicID=30499&ForumID=2&CategoryID=2

--------------------
Penn State Proud

Edited on 8/6/2003 4:58 PM

Title: Re: resurfacing eliminator
Post by: strikealot on August 06, 2003, 04:53:35 PM

i want to get it back to its original surface, out of box condition.
--------------------
nothing ventured nothing gained  

Title: Re: resurfacing eliminator
Post by: DON DRAPER on August 06, 2003, 06:20:11 PM

if you want the ORIGINAL, OUT OF THE BOX condition, have your pro shop resurface the ball as much as needed, perhaps all the way down to the 35 micron trizact pad. then use the smoother grits of trizact and finally finish the ball off with the white, cerium oxide pad.