BallReviews

Equipment Boards => Brunswick => Topic started by: AdrianS on February 26, 2007, 07:56:36 PM

Title: Smoothing out the Hyper Zone (again)
Post by: AdrianS on February 26, 2007, 07:56:36 PM

OK, tried surface changes a few times on this thing and now its in the shop. Thinking of swinging the pin down to 2" from my pap to smooth out the backs now. Anyone used this drill on any of their inferno(or inferno remake) stuff?
--------------------
Time for some REAL bowling!!!

Title: Re: Smoothing out the Hyper Zone (again)
Post by: dizzyfugu on February 27, 2007, 04:41:00 AM

How is the ball currently drilled, and has it an x-hole?
How about just adding a balance hole above your PAP to tame down the back end? Will reduce flare (thorugh less top/side weight) and prevent the ball from being plugged and re-drilled.
--------------------
DizzyFugu - Reporting from Germany
"Put some make-up on your face -  Make this world a better place!"
Kahimi Karie, 'Good morning world'

Title: Re: Smoothing out the Hyper Zone (again)
Post by: AdrianS on February 27, 2007, 05:03:01 AM

Already plugged the thumb, plus i gotta heap of stuff with this layout(pin under bridge, kicked out cg, hole 5 1/2 from grip centre) So i can afford to experiment with a ball or 2.
--------------------
Time for some REAL bowling!!!