BallReviews

General Category => Coverstock Preparation => Topic started by: Boss_Hog on September 02, 2012, 01:59:48 PM

Title: Adjustment Question
Post by: Boss_Hog on September 02, 2012, 01:59:48 PM

I have a Nexus Solid finished 1000, 2000, 4000. Pin about an inch under ring finger, with CG below that.

I have a CSystem 4.5 with similar layout pin maybe an inch above with CG out just a little.

Basically I'm wanting the 4.5 for use when the lanes start to go and the nexus is going through the face.  I was thinking 4000 and rough buff.

Thoughts?

Title: Re: Adjustment Question
Post by: Good Times Good Times on September 02, 2012, 02:57:39 PM

BossHog, what if you tried your 4.5 @1000 for about 30-35 seconds and hit it with a used 2000 pad for about 10 and then applied a snake oil finish?  That will allow you to get downlane but the ball will still have some teeth to corner.