win a ball from Bowling.com

Author Topic: back to 3000  (Read 5534 times)

JohnN

  • Sr. Member
  • ****
  • Posts: 311
back to 3000
« on: January 22, 2019, 03:56:46 PM »
Going to resurface and de-oil a friend of mines' Storm Lock. Factory is 3000 sanded. Will start at 360 and de-oil. What grits after that ? Was thinking 500-1000-2000-3000.

 

Tommy716

  • Full Member
  • ***
  • Posts: 208
Re: back to 3000
« Reply #1 on: January 22, 2019, 04:48:41 PM »
I have a old (2012) Roto Grip for 3000

3000-grit:
1. 500-grit Abralon® - Sand for 30 seconds on all four sides with firm pressure 2. 3000-grit Abralon – Sand for 10 seconds on all four sides with light pressure

JohnN

  • Sr. Member
  • ****
  • Posts: 311
Re: back to 3000
« Reply #2 on: January 22, 2019, 04:53:45 PM »
Wouldn’t that be considered 500-3000 ? The Lock is straight 3000.

SVstar34

  • Hero Member
  • *****
  • Posts: 5451
Re: back to 3000
« Reply #3 on: January 22, 2019, 05:08:00 PM »
Wouldn’t that be considered 500-3000 ? The Lock is straight 3000.
If you search Storm Bowling Surface Chart you can look at a PDF published by Storm.

500 - 3000 is the recommended steps as shown by Tommy above

JohnN

  • Sr. Member
  • ****
  • Posts: 311
Re: back to 3000
« Reply #4 on: January 22, 2019, 05:17:40 PM »
Where can I find the surface chart ?

JohnN

  • Sr. Member
  • ****
  • Posts: 311
Re: back to 3000
« Reply #5 on: January 22, 2019, 05:18:59 PM »
Found it , thanks.