BallReviews
General Category => Coverstock Preparation => Topic started by: skevr on June 22, 2009, 02:00:19 AM
-
I have a ball spinner and I would like to know the proper way to sand.Some have mentioned 4 side sanding as well as 6 sides. Which is best?
-
Honeslty....I prefer two sided sanding, it gets the job done. If I am resufacing the ball then I usually run a 4 sided sanding until I get past 1000, then go back to two sided.
6 sided is overkill.
-Kevin
--------------------
www.ValentinoBowling.com
makers of Snake Oil, Remedy RX, Resurrection & UFO
Premium Maintenance Products