win a ball from Bowling.com

Author Topic: Hand layering multiple grits using all 6 sides of a ball  (Read 440 times)

4for7

  • Newbie
  • *
  • Posts: 3
Hand layering multiple grits using all 6 sides of a ball
« on: November 13, 2020, 02:08:25 PM »
I am familiar with doing the circular motion all over the ball and know I could just do that with each grit layer. But I want to make sure to get all 6 sides for a smoother control than skip a grit.
I do know how to position the ball properly for each side and I do not want to use skip a grit. Just want to layer 500, 1000, 2000, maybe 3000 maybe will just use Trizact 5000 instead of the 3000.
I normally do side 1 then 2 with the track. 3 and 4 across the track and 5 and 6 with the track again.
My question is do I do successive layers on one side at a time with each grit or do all 6 sides with a grit and then do the remaining sides in succession?
Thanks for any insight. 4for7

 

johns811

  • Hero Member
  • *****
  • Posts: 1074
Re: Hand layering multiple grits using all 6 sides of a ball
« Reply #1 on: November 17, 2020, 07:46:55 AM »
All sides with each grit, then repeat with next grit.

4for7

  • Newbie
  • *
  • Posts: 3
Re: Hand layering multiple grits using all 6 sides of a ball
« Reply #2 on: November 17, 2020, 09:40:26 AM »
Thank you

duvallite

  • Hero Member
  • *****
  • Posts: 671
Re: Hand layering multiple grits using all 6 sides of a ball
« Reply #3 on: November 17, 2020, 08:20:36 PM »
+1
That's how I do it too.