win a ball from Bowling.com

Author Topic: Using CABs on Spinners - Worthwhile?  (Read 1251 times)

duvallite

  • Hero Member
  • *****
  • Posts: 703
Using CABs on Spinners - Worthwhile?
« on: November 07, 2009, 06:15:50 AM »
Like the title says.  I just ordered the new Innovative 1/2 hp spinner and some Abralon pads to make it easier to tweak ball at home.  Is it worthwhile to buy a CAB or two to use with the pads, or can you do just as good a job by hand?  The CABs seem pretty pricey, but if they work better and are recommended, then I would get 1 or 2.

 

J_Mac

  • Hero Member
  • *****
  • Posts: 6778
Re: Using CABs on Spinners - Worthwhile?
« Reply #1 on: November 07, 2009, 02:31:53 PM »
Lower grit CAB blocks do a good job of not making flat spots around holes on major resurfaces.  If you were to just use your hand and wet/dry sandpaper or a foam backed abrasive you'll end up flattening out areas around holes.

If you don't have access to a router or plug cutter for cutting down plugs they also do a good job of maintaining the balls contour after cutting those down with files.
--------------------
If you were both cross-eyed and dyslexic, would you see okay?

charlest

  • Hero Member
  • *****
  • Posts: 24524
Re: Using CABs on Spinners - Worthwhile?
« Reply #2 on: November 07, 2009, 03:37:11 PM »
If you're in a pro shop, doing this kind of stuff a lot, I can see the use of a CAB. I am not and I have a CAB for plain sandpaper and one for Trizact (they use opposite parts of the velcro).  and I've even stopped using them for the Trizact, mostly because I have to change the pads for different grits.

They're handy if you have one for each grit but at a minimum of $25 per and some places charge as much as $35 per CAB, that's way too expensive of an unnecessary accessory.
--------------------
"None are so blind as those who will not see."
"None are so blind as those who will not see."