BallReviews
General Category => Drilling & Layouts => Topic started by: CharlieBrown on April 29, 2004, 04:09:44 AM
-
Hi,
I’m a beginner in terms of the technical side of bowling.
Just bought a X-Factor today. I want it to go long and flip, the ball has a ½ inch pin placement, and the pin, cg and mass bias (RAD) are not in line. Top weight is 1.75 ounce.
Ball was drilled with the pin slightly above and to the right of ring finger (right-handed), and the mass bias (RAD) swinging to the right (about 1 inch to the right of thumb hole)
Pin is 3.75 inches from PAP. Balance hole is below the perpendicular axis line.
Question:
1. ½ inch pin placement, is that ok?
2. I was told by someone that a ‘good’ ball should has the pin, cg, and mass bias in line, but my driller said with the drilling above, I should still get the reaction (long and flip) that I’m looking for (even with them not in line, and the small pin placement), who is correct?
Many thanks!!
p.s. I haven’t had the chance to use the ball yet.
p.p.s. Sorry, the same post is on the Storm Forum, but I thought I may get better response here.
-
The CG may be mismarked. This is common. The 1/2 inch pin placment might give you less flip, but it wont make that much of a difference.
--------------------
My Bowling Clinic Site: http://csbowling.vze.com
ASK A PRO:http://csbowling.vze.com/atp.shtml
www.bowlersdream.com - save an additional $3 off any $100 order by simply typing in CSB into the coupon code area at checkout.