BallReviews

General Category => Drilling & Layouts => Topic started by: ten on the deck on January 04, 2012, 12:20:20 PM

Title: 811A SE drilling layout?
Post by: ten on the deck on January 04, 2012, 12:20:20 PM

I currently have a 718A drilled with a dual thumb layout (I believe my  driller said it was a 60 x 30?)  Has a weight hole just to the right of  my thumb hole (RHB)
 I Have an 811A on order & looking for any suggestions on a layout  for this ball.  I am looking for it to get into a roll a bit sooner than  the 718A when the 718 is going too long.  I love the way the 718A rolls  with the dual thumb layout but not sure if the two balls would be to  close in motion if I have the 811A drilled to the same layout.
 thanks for the input.

Thanks for any help.

 

Ten on the Deck.......
"Never confuse activity with accomplishment"
Gene Stallings

Title: Re: 811A SE drilling layout?
Post by: JohnP on January 05, 2012, 10:35:34 AM

The double thumb layout is the strongest available, that means it rolls very early.  You'll have to use surface adjustments to get the 811A to roll earlier.  --  JohnP