BallReviews
General Category => Drilling & Layouts => Topic started by: stormerjip on June 25, 2008, 01:34:49 PM
-
i know this might sound weird but if i lay out a symetrical ball with with same measurements and imaginary mb same as asym ball with asym flip drilling how are the two going to compare similar ball characteristics and everything
--------------------
show no mercy, kill the wounded, eat the dead
Edited on 6/25/2008 9:35 PM
-
Which Assym flip drill are you referring to?
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009
-
i ddint know there was more than one i have it on a file and its call me's asym flip drilling
--------------------
show no mercy, kill the wounded, eat the dead
-
A typical flip drill would be a 5.5" pin high and the MB at 45 degrees. However, on an Assym a 2" pin is also considered a flip drill because it keeps the flare rings tight, and down lane the strength of the core will make it flip. On a symm it also keeps the rigns tight BUT the core is so stable it just rolls.
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009