BallReviews

General Category => Drilling & Layouts => Topic started by: Rob816 on July 29, 2003, 11:55:15 PM

Title: Balance hole question
Post by: Rob816 on July 29, 2003, 11:55:15 PM

Almost everything I've seen says a balance hole most likely be required with a 4x2 drilling. I want to get a Hammer Diesel Partical w/ a 3" pin. Is there any way I can set this ball up w/ a 4x2 drilling and not need a balance hole? If the ball has extremely low top weight prior to drilling will this help with not needing a balance hole?

Thanks for the help

Title: Re: Balance hole question
Post by: Doug Sterner on July 30, 2003, 03:01:25 PM

The lower the better for the top weight on that drill if you dont want a weighthole.
--------------------
Doug Sterner
Doug's Pro Shop
Owego, NY
http://dougsproshop@aol.com
www.dougsproshop.net
Think about it....pins are wood, lanes are wood...
the weapon of choice is obvious...
CUT 'EM UP BABY it's BUZZSAW TIME!!!

Title: Re: Balance hole question
Post by: omegabowler on July 30, 2003, 03:02:22 PM

prejudice against balance holes?. you need what you need to make it leagle.

a low top weight will use a smaller hole.

depends on your pap also. 2" for you is not the same 2" for me.

you may get away with drilling the fingers deep or something like that.
--------------------
"deserves got nothing to do with it."
-- William Munny