BallReviews

General Category => Drilling & Layouts => Topic started by: A_P_K on September 10, 2003, 07:57:23 PM

Title: degree layout system
Post by: A_P_K on September 10, 2003, 07:57:23 PM

How do you determine the degrees of your layout?  This confuses me.....still
--------------------
In the old days people used to cut wood with axes.....................now and days...............they just have Executioners do it for them!

Pin_Krusher IS a serious threat to modern day bowling wood as we know it today.

Title: Re: degree layout system
Post by: omegabowler on September 11, 2003, 03:34:07 PM

according to Denny T. who write article in BTM.

draw a line from your pap to pin. now draw a line from your pin to cgor mb.

you should have a v. the angle is between these two lines.




--------------------
"deserves got nothing to do with it."
-- William Munny

Title: Re: degree layout system
Post by: A_P_K on September 11, 2003, 03:34:52 PM

Thanks Omega
--------------------
In the old days people used to cut wood with axes.....................now and days...............they just have Executioners do it for them!

Pin_Krusher IS a serious threat to modern day bowling wood as we know it today.

Title: Re: degree layout system
Post by: TECH SUPPORT on September 11, 2003, 03:56:41 PM

It helps to have a 1/4 scale with a protractor/degree markings.
--------------------
I have taught you every thing I know and you still dont know DICK.