BallReviews
General Category => Drilling & Layouts => Topic started by: MegaMav on November 09, 2006, 06:35:50 AM
-
Here is a small information section about this ball...
http://bowlingballreviews.com/ball.asp?ballid=269
2-Piece asymmetric, I bought from buddies pro shop used.
core ---> http://bowlingballreviews.com/images/balls/270-1.jpg
Same ball that Bill from buddies wrote up.
Fully plugged and ready to drill, not sure what is marked and what isnt, I should be getting the ball tomorrow.
I can remap the ball, if I can find out Bill's PAP.
Assuming its all marked and ready to go, what drilling would you recommend for this ball? im looking to use it for dry conditions, straight up 10 to roll over and hit, small belly shot at most from 12 to 7, nothing crazy as its urethane.
this should be a fun project, im a tweener that likes to play straighter PAP is 4 3/4" over and 1/2" up
Thanks guys!
Eric
--------------------
USBC Certified Bowler
2005-06 Average: 197 (Non-THS (http://"http://www.bowlingball.com/info/Article_Christmas_Tree_Pattern.html"))
Arsenal Details (http://"http://www.allbowling.com/registry/public.php?regid=134") | My Season (http://"http://bowlingtracker.no-ip.org:2222/personalstats/ViewStats.asp?PS_LeagueID=7026")
Edited on 11/13/2006 6:41 PM
-
even on an asymmetric?
anyone else?
-
I have found out that the locator PIN on this ball is a Z-Axis pin like the ones seen on Ebonite Bombs Away and Brunswick Phantoms.
I'm not familiar with this type of setup, please help!
so the locator PIN is located above the midline, any suggestions?