BallReviews

General Category => Drilling & Layouts => Topic started by: johns811 on July 01, 2020, 07:05:22 AM

Title: Drilling the pin out?
Post by: johns811 on July 01, 2020, 07:05:22 AM

I'm thinking of laying out a ball that puts the pin in the ring finger. Using finger grips, do you position the pin right in the center of the hole/bit? I was going to position the pin to the right edge of the hole guessing of the pin pitch is 0, the ring finger being 3/8" right the bit would remove it all, the holes would not cross paths. Or maybe the pin hole is so small it won't matter and just center the bit.

Title: Re: Drilling the pin out?
Post by: itsallaboutme on July 01, 2020, 12:09:31 PM

Pin in the center of the hole in case there are any voids around the pin.

Title: Re: Drilling the pin out?
Post by: johns811 on July 01, 2020, 01:07:24 PM

Quote from: itsallaboutme on July 01, 2020, 12:09:31 PM

Pin in the center of the hole in case there are any voids around the pin.

thanks, didn't consider that