BallReviews

General Category => Drilling & Layouts => Topic started by: rico4life on March 21, 2013, 11:52:14 PM

Title: dual angle drilling
Post by: rico4life on March 21, 2013, 11:52:14 PM

I am planning on having my ball driller use the dual angle system for my next ball, question is does anyone have a picture of a mo pinel 10 degree drilling that replaces a axis leverage drilling. I just want to have some idea what it should look like, we want this ball to get into a roll very early for heavier conditions.

Title: Re: dual angle drilling
Post by: J_Mac on March 22, 2013, 12:11:20 AM

I'll look, but keep in mind every layout looks slightly different because everyone's axis point is not the same.

FWIW - If you have low tilt (10 degrees or less) my suggestion is to try the double thumb layout... if you have high tilt (20 degrees or more) the 10° drilling angle will be more appropriate.

That being said, any suggestion I'm giving is based on incomplete data... you haven't listed tilt, rotation, etc...

Below are 4 miscellaneous layouts with angles and pin to PAP distances.  First one on the left may be close to what you're after....

Title: Re: dual angle drilling
Post by: rico4life on March 22, 2013, 10:58:17 AM

thanks for the first picture, just wanted to know difference between axis leverage, and 10 degree. My ball driller wanted to do a axis leverage drilling for heavier oil, but mo says the 10 degree replaces axis leverage.

Title: Re: dual angle drilling
Post by: Impending Doom on March 22, 2013, 12:10:13 PM

It's the same thing.

Title: Re: dual angle drilling
Post by: Xcessive_Evil on March 25, 2013, 02:27:36 AM

Quote from: Impending Doom on March 22, 2013, 12:10:13 PM

It's the same thing.

+1