BallReviews
General Category => Drilling & Layouts => Topic started by: htotheizzo3561 on September 02, 2016, 12:47:42 PM
-
How do you or is there a way to adjust after applying dual angle and realizing that a portion of the pin will be drilled or end up with fingers very close to the pin?
example, i laid out 40x4x60 on a ball and the pin would have been half drilled out by my ring finger. so moved everything down about 1/2 inch and now the dual angle is 50x5x60. probably not a huge difference in ball motion but a difference nonetheless
-
Adjust the layout so the pin is in the finger hole. -- JohnP