win a ball from Bowling.com

Author Topic: Exactacator instructions  (Read 4691 times)

J_w73

  • Hero Member
  • *****
  • Posts: 2554
Exactacator instructions
« on: July 15, 2023, 01:32:23 AM »
Does anyone have instructions for the Exactacator thumb mold system?  Do you cast your thumb hole, create the slug, and then install the slug at 0 / 0 pitch?  Are the pitches built into the mold?  It would seem this is the case, but then how would the exactacator work with thumb holes that have extreme pitch?  To me, it looks like the system wouldn't be able to accommodate large pitches.
350 RPM, 17 MPH

 

itsallaboutme

  • Hero Member
  • *****
  • Posts: 2013
Re: Exactacator instructions
« Reply #1 on: July 17, 2023, 07:32:03 AM »
center the mold in the cylinder when you create the slug then drill the hole with pitch

J_w73

  • Hero Member
  • *****
  • Posts: 2554
Re: Exactacator instructions
« Reply #2 on: July 17, 2023, 11:03:36 AM »
center the mold in the cylinder when you create the slug then drill the hole with pitch

But doesn't the mold have pitch built into it?  There must be a step that I'm not understanding.
350 RPM, 17 MPH

itsallaboutme

  • Hero Member
  • *****
  • Posts: 2013
Re: Exactacator instructions
« Reply #3 on: July 17, 2023, 12:48:07 PM »
No, as long as you center the mold in the cylinder when you create the slug. If you have a lot of excess silicone at the base of the mold you will need to trim it to be able to center the mold in the cylinder.

itsallaboutme

  • Hero Member
  • *****
  • Posts: 2013

J_w73

  • Hero Member
  • *****
  • Posts: 2554
Re: Exactacator instructions
« Reply #5 on: July 17, 2023, 01:08:27 PM »
No, as long as you center the mold in the cylinder when you create the slug. If you have a lot of excess silicone at the base of the mold you will need to trim it to be able to center the mold in the cylinder.

Thanks for the info and instructions.  I guess centering the thumb mold into the cylinder is key.  When mine was done there was about a 1/4 inch or more of mold above the hole, so when you put it in the cylinder to create the slug, the mold of my thumb has the pitch.  I guess you are supposed to shift the mold so that the thumb is centered in the cylinder. I don't think that was done.
350 RPM, 17 MPH

som

  • Newbie
  • *
  • Posts: 1
Re: Exactacator instructions
« Reply #6 on: October 01, 2023, 02:38:13 AM »
finger drilled on the dot on a bowling ball