BallReviews

General Category => Drilling & Layouts => Topic started by: robospare on September 25, 2006, 07:54:32 AM

Title: Good layout for high speed low rev bowler
Post by: robospare on September 25, 2006, 07:54:32 AM

Playing up the boards between 8 and 12.
Thanks

Title: Re: Good layout for high speed low rev bowler
Post by: dizzyfugu on September 27, 2006, 02:55:54 AM

Hard to make a recommendation, since it depends on oil volume and your PAP. But basically, I would suggest a strong stacked leverage drilling to make the ball finish at all with low revs and high speed: Pin at 3 3/8" from your PAP, the CG "below" it in parallel to the midline.

Depending on the amount of oil, you might also consider a solid reactive or particle ball with a matte surface to enhance grip. A pearl ball might not be the best basic ball choice, only if you face light or short oil.

Hope this helps a bit?
--------------------

DizzyFugu - Reporting from Germany
Team "X" website & more about me: http://web.mac.com/timlinked/iWeb/X/Thomas.html
"The Future's So Bright I Gotta Wear Shades" - Pat MacDonald

Title: Re: Good layout for high speed low rev bowler
Post by: kmanestor22 on September 27, 2006, 12:17:11 PM

Rev leverage or something that kicks the cg out and down low so you could put a weight hole in the lower quadrant.  I've seen this work for a lot of guys with low revs.
--------------------
Where is the bait?  I'm goin' to jail!!! - Chocolate GAYzer

Title: Re: Good layout for high speed low rev bowler
Post by: northshoremb on January 15, 2024, 05:11:27 PM

Bump

Title: Re: Good layout for high speed low rev bowler
Post by: svengali on January 15, 2024, 10:30:19 PM

10x3.5x60

Title: Re: Good layout for high speed low rev bowler
Post by: MJS73 on January 18, 2024, 02:05:48 PM

Quote from: svengali on January 15, 2024, 10:30:19 PM

10x3.5x60

10 as the first angle is going to going to get into its roll at the dots and be all done by the arrows.