win a ball from Bowling.com

Author Topic: Good layout for high speed low rev bowler  (Read 28583 times)

robospare

  • Sr. Member
  • ****
  • Posts: 291
Good layout for high speed low rev bowler
« on: September 25, 2006, 07:54:32 AM »
Playing up the boards between 8 and 12.
Thanks

 

dizzyfugu

  • Hero Member
  • *****
  • Posts: 7606
Re: Good layout for high speed low rev bowler
« Reply #1 on: September 27, 2006, 02:55:54 AM »
Hard to make a recommendation, since it depends on oil volume and your PAP. But basically, I would suggest a strong stacked leverage drilling to make the ball finish at all with low revs and high speed: Pin at 3 3/8" from your PAP, the CG "below" it in parallel to the midline.

Depending on the amount of oil, you might also consider a solid reactive or particle ball with a matte surface to enhance grip. A pearl ball might not be the best basic ball choice, only if you face light or short oil.

Hope this helps a bit?
--------------------

DizzyFugu - Reporting from Germany
Team "X" website & more about me: http://web.mac.com/timlinked/iWeb/X/Thomas.html
"The Future's So Bright I Gotta Wear Shades" - Pat MacDonald
DizzyFugu ~ Reporting from Germany

kmanestor22

  • Hero Member
  • *****
  • Posts: 969
Re: Good layout for high speed low rev bowler
« Reply #2 on: September 27, 2006, 12:17:11 PM »
Rev leverage or something that kicks the cg out and down low so you could put a weight hole in the lower quadrant.  I've seen this work for a lot of guys with low revs.
--------------------
Where is the bait?  I'm goin' to jail!!! - Chocolate GAYzer

northshoremb

  • Jr. Member
  • **
  • Posts: 76
Re: Good layout for high speed low rev bowler
« Reply #3 on: January 15, 2024, 05:11:27 PM »
Bump

svengali

  • Full Member
  • ***
  • Posts: 112
  • U$BC Member
Re: Good layout for high speed low rev bowler
« Reply #4 on: January 15, 2024, 10:30:19 PM »
10x3.5x60
"There's no reason to practice, you just bowl good when the left's walled"
Patrick Allen

MJS73

  • Full Member
  • ***
  • Posts: 179
Re: Good layout for high speed low rev bowler
« Reply #5 on: January 18, 2024, 02:05:48 PM »
10x3.5x60
10 as the first angle is going to going to get into its roll at the dots and be all done by the arrows.