BallReviews
General Category => Drilling & Layouts => Topic started by: rico4life on February 27, 2017, 10:26:48 PM
-
can someone tell me the difference between rev leverage and axis leverage?
-
Forget about named layouts :) Just learn what dual angles you like and go from there... but literally anything "leverage" the pin is 3 3/8" from PaP.. so axis lvg the pin is 3 3/8" from PaP and the cg was put on PaP with it drilled out.. Rev lvg the cg is 3 3/8" from PaP but in the thumb/positive quadrant w/ a hole 6 3/4" on a line from pin through cg ..
-
I used to use dual angle, had a alpha crux drilled today, we looked at other ball I like a lot which was a axis leverage drilling. We did figure out that a 20x20x3 dual angle drilling works best for me. Don't really know why this works so well for me it just does, hooks as much as I wanted and never quits. my pap is 4 1/2 and 3/4 up.
-
I used to use dual angle, had a alpha crux drilled today, we looked at other ball I like a lot which was a axis leverage drilling. We did figure out that a 20x20x3 dual angle drilling works best for me. Don't really know why this works so well for me it just does, hooks as much as I wanted and never quits. my pap is 4 1/2 and 3/4 up.
Are you strongly speed dominant with a lot of axis tilt and rotation? -- JohnP
-
I do throw it about 16-18 mph don't think I have a lot of tilt or rotation, but have always been able to throw a ball through the heads pretty easily, have tried storms 4x4x2 drilling on a storm lock, had to play down and in up 5-8 board.