win a ball from Bowling.com

Author Topic: Removing a VISE "IT"  (Read 1964 times)

LexiusLefay

  • Jr. Member
  • **
  • Posts: 17
Removing a VISE "IT"
« on: February 18, 2011, 11:41:53 PM »


I just got a ball from Ebay with an "IT" installed.  Since no one in my area has this, how do you remove an "IT" installation in a ball?  My proshop is old school and hasn't done these before.  Thx.





 

Stan

  • Hero Member
  • *****
  • Posts: 667
Re: Removing a VISE "IT"
« Reply #1 on: February 19, 2011, 10:43:42 AM »
You can put a thin screw driver between the top sleeve and the ball and carefully pry it out.  Then you can use a 1 1/4 drill and drill out the ball-it.  Without moving the ball, insert a 1/2 drill bit and drill out the safty molly.  Then plug the ball.