BallReviews

General Category => Drilling & Layouts => Topic started by: hwest2 on April 13, 2009, 12:32:09 AM

Title: pin and top weight
Post by: hwest2 on April 13, 2009, 12:32:09 AM
What would be a good combination of pin and top weight if you wanted to drill a ball pin under 4 inches  and use an xtra hole or not  to fine tune a balls reaction??
Title: Re: pin and top weight
Post by: JohnP on April 13, 2009, 09:53:50 AM
What's your PAP, span, and how high above the midline do you want the pin to be?  --  JohnP
Title: Re: pin and top weight
Post by: hwest2 on April 13, 2009, 11:13:27 AM
quote:
What's your PAP, span, and how high above the midline do you want the pin to be?  --  JohnP
Pap is around 5 inches and span 41/4 Just looking for an approximate answer,Thanks
Title: Re: pin and top weight
Post by: JohnP on April 13, 2009, 11:22:11 AM
Top weight 2 1/2 - 3 oz.  If you want the pin under the fingers, 1 - 2" pin out.  If you want it over the fingers, 3 - 3 1/2" pin out.  --  JohnP