BallReviews
General Category => Drilling & Layouts => Topic started by: jackson93 on January 30, 2019, 04:37:33 AM
-
Hi Guys!
I’m two handed no thumb bowler with a high track. Just looking for some suggestions and help on a problem.
Usually with pin down layouts I’ll drill pin under bridge cg kicked out roughly an 1†with a weight hole in the thumb area usually under the cg. I’ll roughly measure 4†down and 1/2†across for my weight holes
So I’ve got a a couple of new balls(symmetrical) I’m wanting to drill pin down without a weight hole, but I’m worried that the bow tie is gonna clip my middle finger and thump real bad. Usually when I put the extra hole it raises the bow tie just enough to not be a problem.
Any help or ideas on this would be awesome!
Jackson
-
Focus on pin to pap vs up or down. In your case keep the pin in the fingers or above. 5" pin up or down will be very similar.