BallReviews

General Category => Drilling & Layouts => Topic started by: youthbowl on March 25, 2007, 09:14:02 AM

Title: Pin in
Post by: youthbowl on March 25, 2007, 09:14:02 AM

What could you do with a pin in ball for a med-high tracker?  I'm looking to get a Gold Rhino Pro to fit under my H20 drilled pin above and to the right of the ring finger and mb to the right of the thumb.  What do you guys think?
--------------------
AIM=donutsbrian

Title: Re: Pin in
Post by: JohnP on March 26, 2007, 10:40:49 AM

Depending on the top weight, most layouts can be used as long as you don't mind a large balance hole and/or extra deep finger holes.  If you don't want a balance hole, you're going to be limited to layouts with the pin close to grip center, which may flare over the finger holes.  --  JohnP

Title: Re: Pin in
Post by: youthbowl on March 26, 2007, 04:44:04 PM

The top weight is 2.5 oz.
--------------------
AIM=donutsbrian

Title: Re: Pin in
Post by: JohnP on March 27, 2007, 10:28:04 AM

That's more flexible than higher TW's.  Talk to your driller and tell him what you want the ball to do.  Look at the drill sheet that came with the ball for help in selecting a layout.  Almost all of them should work using deeper finger holes and/or a balance hole.  --  JohnP