BallReviews

General Category => Drilling & Layouts => Topic started by: Win4Fun on May 04, 2003, 05:22:04 AM

Title: Please help
Post by: Win4Fun on May 04, 2003, 05:22:04 AM

I am trying to find the exact center of grip on my ball. I located my PAP but I am not sure how the center of grip is measured. Do you measure using:

a) the center of the holes where the drill bits are placed?
b) the edge of the finger and thumb holes (where my fingers and thumb touch the inserts) or
c) cut to cut?

If it makes any difference, I use finger and thumb inserts. Any help would be greatly appreciated. THANKS

Title: Re: Please help
Post by: SrKegler on May 04, 2003, 09:38:03 PM

Either way would work, easiest is draw a line under the lip of the finger holes, measure from that line straight to the edge of the thumb hole, take 1/2 the distance to find the center of the grip.

Title: Re: Please help
Post by: 10 In The Pit on May 05, 2003, 02:20:16 AM

Yep, the gripline center runs from the middle of the finger bridge straight down through the center of the thumbhole.  Then you can measure either the distance cut to cut or hole center to hole center between the thumbhole and fingerholes, and take half of the distance to find the center of grip.