win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Layout Suggestion  (Read 1151 times)

pin-chaser

  • Hero Member
  • *****
  • Posts: 1802
Layout Suggestion
« on: October 08, 2006, 10:06:08 AM »
I have Black Widow with a 2.5" pin and 2.5oz top. My pap is 5.5" x 1/2" up with about 320 to 350 rev rate.

I am looking for energy retention and continuation through the pit on THS (39' pattern) after breakdown. Looking at the drill sheet it says 5.5" pin to pap and 45 degree mass bias but that is for pin lengths of 3-5. But laying it out that way puts the MB close to the VAL.

Any suggestions?
--------------------

Bowling Tips and Articles at: www.bowlingknowledge.com
IRC: Internet Relay Chat on Dalnet #striketalk. 24x7x365
Logged
Sponsored by: http://bowlerx.com



Chasing pins for 45 years.

 

the pooh

  • Hero Member
  • *****
  • Posts: 615
Re: Layout Suggestion
« Reply #1 on: October 08, 2006, 07:36:57 PM »
I have one with that exact layout and I love it! You can still do the layout with the pin above fingers,you will just have to take the fingers deep to get the finger weight legal.Another possibility would be to do the same layout(5.5x45 degrees} with the pin under fingers.This should put the cg nearer to the midline,allowing the finger weight to be legal without taking them deep.Depending on your balls hmb alignment,you may not even need a weight hole;mine did not.
--------------------
the pooh
Logged
the pooh

kmanestor22

  • Hero Member
  • *****
  • Posts: 969
Re: Layout Suggestion
« Reply #2 on: October 08, 2006, 08:10:04 PM »
You could put the pin below your bridge which should still be 5-1/2".  Putting the MB close to the VAL seems Ok with this ball, it still retains energy.  Also with the pin below the bridge you can usually go with a low weight hole.  I have thrown one 4-1/2" pin to PAP, 45 deg MB, low weight hole 3" off thumb and it hooks a ton.  It has great continuation, even the third game.
--------------------
Where is the bait?  I'm goin' to jail!!! - Chocolate GAYzer

Edited on 10/8/2006 8:03 PM
Logged

pate08

  • Hero Member
  • *****
  • Posts: 877
Re: Layout Suggestion
« Reply #3 on: October 12, 2006, 10:13:04 PM »
Pin above bridge with cg and mass bias lined up at about 5 o'clock and a weight hole to the right of the cg. It's an aggressive drilling. Go to bowlingball.com and there are some links at the top and one of them is drilling patterns, go there and you can find some good ones
--------------------
Infinite One
Columbia Action
Radical Inferno
NuLine Virus
AMF Victory SPT
Track Crunch Time - retired
University of Texas spare ball


High Game - 286
High Series - 748
 
Logged
Pages: [1]
« previous next »