win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: question about switch grip  (Read 1659 times)

stormerjip

  • Hero Member
  • *****
  • Posts: 1163
question about switch grip
« on: July 23, 2008, 04:01:31 PM »
basically I have a pretty simple question.  hoiw much do you allow  from the edge of the hole for outer sleeve  to center of slug fir the span
--------------------
show no mercy, kill the wounded, eat the dead
Logged
show no mercy, kill the wounded, eat the dead

 

raiderh20boy

  • Hero Member
  • *****
  • Posts: 1735
Re: question about switch grip
« Reply #1 on: July 24, 2008, 12:08:58 AM »
I don't understand what you are asking but you have to use a 1 1/2" drill bit for the turbo brand . The Vise allows for a bit 1/16 larger than what size thumb insert you use. You can use 1 1/8 -1 1/4 - or 1 3/8 thumb slug with the "IT" from VISE!!!
Logged

stormerjip

  • Hero Member
  • *****
  • Posts: 1163
Re: question about switch grip
« Reply #2 on: July 24, 2008, 01:30:17 AM »
what im asking is if ur span is 4 1/2 to actual thumb hole what span do us drill the 1 1/2 inch hole to get it to middle of the other
--------------------
show no mercy, kill the wounded, eat the dead
Logged
show no mercy, kill the wounded, eat the dead

EboHammer4ever

  • Hero Member
  • *****
  • Posts: 578
Re: question about switch grip
« Reply #3 on: July 24, 2008, 06:36:07 AM »
With the Griploc system, I measure back from the cut of the middle finger to the cut of sleeve and drill it from there.  Once you do it on one ball, all you have to do is use this measurement and hit your lines and your good.  I do even put the insert in the sleeve and measure for the fingers anymore.  Hope that helps.
Logged

Corey C

  • Sr. Member
  • ****
  • Posts: 348
Re: question about switch grip
« Reply #4 on: July 28, 2008, 09:35:27 PM »
Are you drilling the ball? Map out the span as usual, line up the thumb with your regular size bit and pitches, then take it out and put the outer sleeve bit in the chuck and drill the hole.

 OR

The outer sleeve is 1/16" thick, and the inner sleeve is 1/16" thick = 1/8 total. The slug is 1 1/4". Half of 1 1/4" is 5/8" plus 1/8"= 3/4" from the center of the slug to the outer.

Clear as mud!!??
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009
Logged
Corey Clayton
Brunswick Regional Staff
Turbo Staff
Pages: [1]
« previous next »