win a ball from Bowling.com

Author Topic: drilling for vendetta black solid  (Read 617 times)

stormerjip

  • Hero Member
  • *****
  • Posts: 1162
drilling for vendetta black solid
« on: March 30, 2006, 09:44:37 AM »
I throw about 18mph above average revs I was thinking of drilling with girard layout but i didn't know if there had been problems with high trackers hitting the fingers or thumb with this layout.  I am looking for something controled yet fairly strong and even rolling.  

I have a
pure energy with pin under bridge cg kicked right
vendetta sniper pin over middle cg slight right
vendetta pearl pin over middle cg kicked right
and zr40 pin under bridge cg stacked below
--------------------
show no mercy, kill the wounded, eat the dead

The bowlers solution pro shop
inside amf arc lanes evansville, ind
regional PBA member since 05
formerly known as stormerjip

Edited on 3/30/2006 8:49 PM
show no mercy, kill the wounded, eat the dead

 

jimensminger

  • Hero Member
  • *****
  • Posts: 1845
Re: drilling for vendetta black solid
« Reply #1 on: March 30, 2006, 07:47:15 PM »
I don't think 4 1/2 x 1/4up is high tracking...strong and even for me is usually pin under,..5 x 4, med dullish to a little shine.