before you use it, take a 4000 grit abralon pad to it, that will take the polish off of it and make it a beast in the mids..
--------------------
I think the great slump of 2006-2007 is finally coming to an end!!

I agree with those who have already posted. I have drilled one almost identical (5" pin to pap& 1.5" from val, mb 4" from val). This ball needs very little help getting length. I scuffed it with 4000 and got a midlane read. You may want to consider a little lower pin depending on your revs.

All we are trying to tell you is that the nature of this ball is to go long. A TNV with the same layout and surface as an Angular One will go longer and have more of its hook on the backend. If you have a specific ball/layout to compare it to I/we can try and help. As much as you dont want it to read early, you dont want it to spin into the pit, either. There are some guys with average to below average revs who have used the "Tommy Jones" drilling looking for length and gotten more length than they bargained for.