BallReviews

Equipment Boards => Hammer => Topic started by: TheGom on May 07, 2014, 11:30:35 PM

Title: Cold Blood Surface Changes.....have you tried this?
Post by: TheGom on May 07, 2014, 11:30:35 PM

Looking to see if anyone has polished their Cold Blood and if so, can you tell me how the reaction was and what type of pattern did you use it on?

Title: Re: Cold Blood Surface Changes.....have you tried this?
Post by: SVstar34 on May 07, 2014, 11:39:07 PM

I have one coming to me tomorrow. I'll let you know what I decide to do with mine. I might polish it so I can test it on our house shot since that's the only thing that will be out. Ultimately I'm planning on using it for mainly sport shots only so I'll keep it dull

Title: Re: Cold Blood Surface Changes.....have you tried this?
Post by: LuckyLefty on May 08, 2014, 08:12:34 AM

Just saw one looking great yesterday, I think polished but I will check with him.

Regards,

Luckylefty

Title: Re: Cold Blood Surface Changes.....have you tried this?
Post by: Plowboy300 on May 08, 2014, 02:43:46 PM

I have played with surface adjustments on my 2 - Cold Blood pieces... I actually kept one of them with a 1500 Abranet w/ FF polish on it and rolls pretty sweet. This ball has a pin up layout - 55 x 5 1/4 x 35 layout which was very rolly type of reaction for me... with the polish, it gets through the front part of the lane with a little more pop in the backends, but still a strong rolling piece. Use this ball a lot on the medium length patterns (38-41').... just gives me a strong rolling piece that is not too over/under on the backends.

Hope this helps your questions...

Title: Re: Cold Blood Surface Changes.....have you tried this?
Post by: pin-smasher on May 09, 2014, 12:07:41 AM

I have mine polished, nice length with sharp snap on backend