BallReviews
Equipment Boards => Hammer => Topic started by: Nicanor on March 12, 2009, 01:41:13 AM
-
The CG in or very close to the middle of the palm on almost every drill sheet except the early roll sheet ofr low, medium and high trackers?
I know many say CG doesn't matter and thats ok, but the drill sheet says to go through the center of the span 4-5 inches through the CG. I would think that might put the balance hole in my track.
--------------------
Nicanor (Ten On The Deck)
Edited on 3/12/2009 9:48 AM
-
The CG Zone in their drill sheets is the safe location for the CG placement so no balance hole is needed. If you have the CG away from that area that is where they suggest to put the balance hole.
-
Understood, but why wouldn't they show the cg/mb in other places then the saffe zone?
--------------------
Nicanor (Ten On The Deck)
-
Because pin to pap distance will have the more influence on ball reaction.