BallReviews
General Category => Miscellaneous => Topic started by: pin-smasher on July 04, 2010, 12:37:20 PM
-
Since i have just started to drill my own stuff i decided to get all my balls together and measure them against my drill sheet measurements and i noticed that only a couple of them actually match and all balls were drilled by same person...anyone else ever run into that
-
Unfortunately, that is pretty common.
--------------------
Me, a couple balls, two lanes, all that is right with the world. Bowling is my haven!
-
i always wondered why some balls felt great and some just bugged me....
-
Another reason for buying the KMT Personal Ball Jig. Drill them yourself! www.kmtballjig.com .
Steve
-
Yeah, I think this is all too common. I have since changed shops and no longer run into this problem.
-
quote:
Since i have just started to drill my own stuff i decided to get all my balls together and measure them against my drill sheet measurements and i noticed that only a couple of them actually match and all balls were drilled by same person...anyone else ever run into that
I noticed thr same thing since I also recently started drilling my own balls.They weren't off by much,maybe a 1/16 and they all felt good.I've discovered that the art of putting gripping holes in a bowling ball is an inexact science.
--------------------
The more I practice,the luckier I get.
-
i measured my middle finger hole to hole and on my favorite ball its 4 3/8 and i found a bunch of balls that were 4 1/4 then some were right on the middle finger but off on the ring finger...
-
I had this problem until I switched drillers a few years back, I always wondered why I'd clear ball X a little better than ball Y and this one just felt better than that one.
--------------------
BowlingChat.net (http://"http://www.bowlingchat.net")