BallReviews

General Category => Miscellaneous => Topic started by: johns811 on January 25, 2020, 09:01:40 PM

Title: Finger hole shapes without grips?
Post by: johns811 on January 25, 2020, 09:01:40 PM

I decided to try a ball without grips, I use 3/4 and 23/32 inserts which are a bit oval shaped. The ball without grips the holes are perfectly round so side to side they are perfect from front to back a little loose? Should they be drilled smaller and shaped to fit or should just be taped up a little.

Title: Re: Finger hole shapes without grips?
Post by: ekster on January 25, 2020, 09:44:14 PM

Have PSO oval the finger holes.

Title: Re: Finger hole shapes without grips?
Post by: ignitebowling on January 25, 2020, 11:59:18 PM

I use tape

https://www.amazon.com/Ebonite-Premium-Bowling-Tape-Pieces/dp/B00EARTZZA

Title: Re: Finger hole shapes without grips?
Post by: Pinbuster on January 26, 2020, 06:11:44 AM

My fingers are fairly flat so I they are drilled to fit the narrow part of the finger tip and then I use a file and sander to open up the sides to fit.

Title: Re: Finger hole shapes without grips?
Post by: itsallaboutme on January 26, 2020, 06:52:44 AM

Have them milled oval just as you would a thumb.

Title: Re: Finger hole shapes without grips?
Post by: hd12b on January 26, 2020, 09:49:57 AM

oval works for me.