BallReviews
General Category => Miscellaneous => Topic started by: TDC57 on October 16, 2006, 09:17:30 AM
-
I need help from you guys who know how to set up or drill balls. I have two balls I am going to have drilled.
One is a Roto Grip RS1
Specs: 4-4.5 inch pin
2.50 oz. of top weight
The other is a Storm Power Charge Pearl
Specs: 3-3.5 inch pin
3.72 oz of top weight
I have decided to drill one of them with a basic label leverage drilling. ( A drilling that always works well for me.)
The second ball, I am going to have drilled to go very long but still have some finish on the backend.
Any suggestions on which ball would better fit each setup I have decided on?
Thanks for any help you can offer!!
-
Looking at your profile, I would say drill that RS1 for the length/flip due to your slow ball speed (and not to mention the great pin-out that you have). Put the Pin 5.5-6" from your PAP (this should put it well above your fingers) and place the mass bias about 60-70 degree range. If you feel like you need to smooth out the backend place a weight hole on your PAP and let it rip!
--------------------
Mat Henning
Roto-Grip Staffer
Turbo 2·N·1 Staffer
Owner/Operator of
Champions Bowling Services