BallReviews

General Category => Miscellaneous => Topic started by: thirtyclean on October 02, 2023, 01:02:03 PM

Title: Vise Insertion tool not coming out of ball - HELP !
Post by: thirtyclean on October 02, 2023, 01:02:03 PM

Have drill 100's of balls and the first time this happened. It is spinning but will not release. It will not budge. Ball is an expensive overseas ball and I dont want to mess to much. Has anyone ever run into this .  Any suggestions .

Thanks,

Thirtyclean

Title: Re: Vise Insertion tool not coming out of ball - HELP !
Post by: TWOHAND834 on October 03, 2023, 08:13:55 AM

Quote from: thirtyclean on October 02, 2023, 01:02:03 PM

Have drill 100's of balls and the first time this happened. It is spinning but will not release. It will not budge. Ball is an expensive overseas ball and I dont want to mess to much. Has anyone ever run into this .  Any suggestions .

Thanks,

Thirtyclean

Have you tried securing the ball on the drill press and then using a hammer or something else to hit up on it?