BallReviews
Equipment Boards => MoRich => Topic started by: 86camaroman on September 27, 2008, 02:12:26 AM
-
Hi guys I am going to drill an awesome hook I was thinking of doing it 47x4x30 kind of similar to the ntense that Fred carroll was throwing in his video with the double thumb drilling. What kind of roll should I expect out of the hook with a drill like that. Also any recommendations.
-
Based on the info in your profile 46x4x31 would roll better
-
This drilling would put the pin right above my ring finger and mass bias really close to thumb maybe even drilling into it. I am left handed not cranker but put descent hand on the ball. speed is prolly average 16 17mph
pap is 4 inches over and zero up or down. Any ideas on what this drilling may produce
-
quote:
Any ideas on what this drilling may produce
3 to 4 holes in the ball...
-
I am not experienced in drilling layouts to offer any comments. Why don't you try asking at the MoRich website?
http://www.morichbowling.com/Products/DrillingRequest.htm
--------------------
I am the Sgt Schultz of bowling.
"I know nothing! I see nothing! NOTHING!"
_________________________________________
New to BR? - Please check this: BR FAQ (http://"http://www.ballreviews.com/Forum/Replies.asp?TopicID=74110&ForumID=16&CategoryID=5")