BallReviews

Equipment Boards => Radical => Topic started by: 12XSECH on September 16, 2015, 06:41:57 PM

Title: guru master surface
Post by: 12XSECH on September 16, 2015, 06:41:57 PM

Anybody change the surface of the Master, polish it etc??? If so how did it handle the change?

Title: Re: guru master surface
Post by: tommymo on September 16, 2015, 09:41:59 PM

Took it to 4000 siaair. Put it in the Haus for 2minutes. It's great on our 43ft house shot. Get down the lane a lot better. Still hooks for days.

Title: Re: guru master surface
Post by: UpstateProShopChris on September 16, 2015, 11:12:58 PM

The Guru Master handles surface changes well.  I am using mine at 500 Siaair to control wet/dry conditions and also to hook on heavy flat patterns.

Title: Re: guru master surface
Post by: Lord20352 on September 17, 2015, 07:31:36 AM

I have my Master at 800 and still gets thru the Heads and continues. You can use whatever you desire on this ball.

Title: Re: guru master surface
Post by: 12XSECH on September 18, 2015, 10:07:35 AM

I just got mine the other day, drilled in pin down because I wanted a strong arch. No extra hole was needed. The shot is 43 feet long with a decent amount of oil. The ball is strong! If I was to put a hole in the p3 position, will that make it flare more and read earlier?

Title: Re: guru master surface
Post by: newguy on September 18, 2015, 11:39:28 AM

Yes. A hole at P3 will increase the flare and make it read earlier. Check out the drill sheets on our website to let you know how to increase flare potential on all scoop cores.