BallReviews
Equipment Boards => Roto Grip => Topic started by: normy on November 26, 2009, 09:16:51 AM
-
Im going to be purchasing a Cell from a friend of mine for $30. I dont really need the ball but for 30 I cant pass it up. I have a Dimension drilled pin under and cg kicked out. Surface at 2000. I have a gravity shift drilled pin under ring and mb kicked right. I vary the surface on that between 2000 and 500 with polish.
So what suggestions do yall have for a drilling on it? Its drilled stacked with the pin about an inch to the right of the ring finger. He is a lot higher track player then me. My PAP is 4" and 7\8" up. So that would be a real strong drilling for me. I was thinkin of maybe drilling it stacked with the pin on the left side of the middle finger(Im right handed)? That would make it like 5X5 or so I guess. So any suggestions would be nice.
Basically I want a different look than my other two heavier oil balls.
-
75 x 5.25 x 25. That''ll be much different. Pin will be high, MB will be near the thumb (maybe 1-2" from your track). You''ll get effortless length with revs, but with a Cell your carry should still be great.
*edit for spelling*
--------------------
Dave W - Seismic Staff
www.seismicbowling.com (http://"http://www.seismicbowling.com/")
Edited on 11/26/2009 7:06 PM
-
I would go with something long like suggested. I have a Cell with the pin 3 inches straight up from the bridge. I love it, it revs easy and has a real consistent break point but it does a great job of clearing the heads. Just shot 759 at house known for bad carry with it, so you won't be sacrificing carry.
--------------------
They call me the thread killer...
Always be sincere, even when you don't mean it
The Cell Pimp