Author Topic: Drilling an RSP? (Read 770 times)

ebolanebowler · « **on:** February 27, 2006, 01:37:04 PM »

I am going to purchase an RSP, I do not fear short pins and ca use all topweights I need a drilling suggestion. I am a tweener, average revs, 17-19 mph, Im lookin for a heavy oil ball, should I drill it stacked,Label, or maybe even pin under ring and CG swung out?
--------------------
I hate crankers, they make me LOOK inferior

Jeffrevs · « **Reply #1 on:** February 27, 2006, 11:43:33 PM »

if you're truly looking for heavy oil, you need the cg swung out,....pin under makes most sense.

label is NOT for heavy

stacked isnt' either......

this is a low rg ball anyway, kicking out the cg will help it rev up even earlier to get a better read on wetter conditions
--------------------
JEFF
"...nowhere is the dreamer, or the misfit so alone...."

Author Topic: Drilling an RSP? (Read 770 times)

ebolanebowler

Drilling an RSP?

Jeffrevs

Re: Drilling an RSP?