win a ball from Bowling.com

Author Topic: Erase-It  (Read 25009 times)

admin

  • Hero Member
  • *****
  • Posts: 1241
Erase-It
« on: December 31, 1969, 06:00:00 PM »
Coverstock: Curleyon 2 (Reactive); Factory Finish: Factory sheen; RG: Medium Low; Differential: Medium High; Flare: Medium-High; Length 5 (1-10 scale); Backend: 9 (1 - 10 scale); Hook Potential: 19; Available weights: 12 - 16 ; Recommended lane conditions: Medium Oil

 

BowlingJunkie6

  • Jr. Member
  • **
  • Posts: 15
Re: Erase-It
« Reply #31 on: September 06, 2002, 04:17:19 PM »
First off, I would like to say that Storm is one of my favorite line of balls.  Tremendous hitting power.  However, with the Erase-It, I have tried a couple of different drillings, and have not really found a great reaction from it.

It seems to be too jumpy when heading from oil into the dry, and if there is a lot of oil, I get too much skid out of the ball.  I have left the ball in the out-of-box finish because I wanted a ball that would drive through the oil.  I haven't really seen that capability from this ball.

I first had the ball drilled for an early roll, but the ball never seemed to want to make the turn in oil.  I had it re-drilled for more length, but when I did that, I could not get a consistent break point out of the ball.  Sometimes through the nose, sometimes just skid past the head pin.  I also know that a lot of times, when there is a less than acceptable reaction from a ball, frequently it is the bowler, not the ball.  I also had a couple of teammates throw this ball, with the same inconsistent results.  

On a positive note about the ball, when I could get a good reaction, the ball really does crush the rack.  Not many single pin leaves with the ball.  

From all the positive feedback about this ball, I am actually thinking about getting another one.  This one did have a lot of topweight compared to my other equipment, and I am wondering if this may have been the problem.  

Thanks for reading.

BowlingJunkie6

  • Jr. Member
  • **
  • Posts: 15
Re: Erase-It
« Reply #32 on: September 30, 2002, 08:50:07 AM »
Follow-up review on the Erase-it.  

In my earlier review, I had stated that the Erase-it had been very inconsistent for me on its reaction.  The lanes had been oiled fairly heavily;  I was getting too much over/under with the ball.  However, I also stated that when I could get a good reaction, the ball would just absolutely crush the rack.  The carry was excellent.

Here is my update.  The last 3 weeks at my bowling center, the oil pattern has been clean heads, average amount of oil to around 40 ft., and then drier backends.  I had been trying to decide between using the Erase-it, the Hammer Wheel, and a Black Messenger from Columbia.  I went with the Erase-it, and let me tell ya, it was the right choice for this oil pattern.

Throwing 15 out to around 4-5 board, this ball comes back harder than anything I have ever thrown.  I throw at about 17 MPH, and at that speed the ball carried just about everything.  I don't get too hyped up about scores, because spare shooting counts for a lot.  However, I wanted to mention the low score for three games in these three weeks has been 647.  I left two 10 pins in these 3 weeks, when I have hit the pocket.  It does drive too hard sometimes.  I left three 4-9's, and two stone 8 pins.  The carry with this ball, in the right environment, is absolutely incredible.  I am glad I gave this ball another chance, and also learned something in the process about which pattern to use this ball on.

I wanted to be fair with the review.  I won't use this ball on a long-oil pattern; but for a drier backend, this is definitely the go-to ball.  Good job, Storm, and as always, the Storm hitting power is terrific.  

Thank you for reading.

CaughtbySTORM

  • Jr. Member
  • **
  • Posts: 14
Re: Erase-It
« Reply #33 on: October 01, 2002, 01:12:48 PM »
Absolutely love this ball.  Period.  On oilier conditions, it's a perfect ball.  I have it drilled between length and earlier roll, and it starts to set up early, and then heads straight for the pocket.  It does have a tendency to flatten out a bit, but when it drills the pocket every time, does it matter?  I shot 300 with it (in practice) just a few days after I bought it.  It does excellent with higher speed and revs, which I've gotta push a little to get, but all I have to do is get it to the backend somewhere between 5 and 15 and it punches right through.  Very strong ball, compliment to the awesome Eraser line.

ACE300Bowler

  • Jr. Member
  • **
  • Posts: 7
Re: Erase-It
« Reply #34 on: October 02, 2002, 11:29:10 AM »
This ball i had drilled as a 4x4 leverage weight for backend.  The ball did more than my expectations,  Went long with a strong backend snap right to the pocket.  Not only did it cary strong to the pocket, it wasn't so overpowering that i left nine-pins.  This is one of the most consistant medium oil lane balls i have thrown.  I would recoment this ball to anyone who plays a long skid snap.

Jason R Stacy

  • Jr. Member
  • **
  • Posts: 7
Re: Erase-It
« Reply #35 on: October 15, 2002, 03:29:00 AM »
Well I've had this ball for a while.This ball has a short pin 2in.And is drilled to slide and snap.It is polished.Dam this ball is one of the  smoothest ball I have ever thrown.It rolls up perfect every time and doesn't over react at all.This ball is a 10 out of 10 in my book.


The great one

  • Sr. Member
  • ****
  • Posts: 385
Re: Erase-It
« Reply #36 on: November 20, 2002, 01:20:35 PM »
Have this one drilled up w/my favorite and most common drill patern (pin above and right of ring finger, cg lined up with it below, extra hole) and after loving its brother the eraser, expected more of the same, just a little bit eariler being a solid ball instead of a pearl. Boy was i wrong, this ball has no snap for me unless the backend are stripped. First used it sanded on a heavy patern when my eraser was going a little to long, and this didn't move, polished it up, thinking it would have a little more snap, nope, just more skid. Great ball when the backends are stripped, i'll give it that. If it wasn't for that, it would be the first, only and probalby last strom ball i would dislike.
The pleasure has been yours.
The great one

Hydranine

  • Newbie
  • *
  • Posts: 4
Re: Erase-It
« Reply #37 on: March 08, 2003, 12:07:02 AM »
You can view my profile for most of my specs.  I purchased this ball once plugged from my local driller.  Didnt know much about the ball, just saw it and for the price gave it a shot.  Glad I did as I have loved it ever since.  My Trauma ER is more even hooking, while this goes longer and snaps harder in the last 30% of the lane.  

    I find the nights I bowl best are when I can pull this ball out and use only it.  When I am hunting around for a shot and using 3 different balls throughout the night, it usually is bad news.  I never have problems with Carrydown with this ball, as I am usually able to use it the third game.  If you miss outside, the ball tends to overreact (more the lanes than the ball, but some balls give a smoother bounce off the dry) but that is my fault so not an issue, and rarely happens.  I strongly dislike a person saying a ball "hits or carries" better than another ball, but I will say that this ball usually matches most conditions I face, allowing my carry percentage to be higher than most other balls.  

    I have over 200 games on the ball now, and have not noticed a lack of hitting power, or mellowing out at all, it is still very strong with no resurfaces.  Our lanes on Tuesday (the easier of the two shots I see) is a pattern similar to a 8-8, but it often changes and they like to throw in surprises sometimes.   We usually do not have much bounce room to the outside of 8 as tonight I missed my board 3 right and it came back barely enough to give me a 5-count in the middle of a string of 9!  

    What I will say is this.  For medium-heavy oil and for a person with a fair amt of revs, you can certainly do worse than this ball if you get one.  It is not a miracle ball (no such thing, even the beloved X-Factor or Lane #1 Balls) but if added to the mix of nice revs, medium-high oil, and reasonable speed (16+) you should find yourself a winning combination.  Good Luck and Bowl well!

EboniteSmurf

  • Jr. Member
  • **
  • Posts: 9
Re: Erase-It
« Reply #38 on: March 25, 2003, 02:13:26 PM »
Since I am slowly adding my arsenal to the reviews I have done, I feel it is time to review this one.  Having purchased a Trauma Recovery prior to this ball I wanted a ball that would hook earlier, instead of giving me a late snap reaction.  This ball did that but I can't find a house I can throw it in.  I bowl in two centers during the week on several different patterns, being a mechanic does have one advantage.  This ball consistently rolls out just past the arrows for me, I have only had two good sets with it the first was by spinning the ball and the other was when my wrist was too tired to turn.  Probably the drill and the way I throw the ball cause this situation but it kinda put me off of the storm line for myself. (Except for the SP pearl with the pin in)
Rob Moore
Charlotte, NC

Support your Junior bowlers, they are the future of our sport.

Bowl to Win.....

jokers

  • Newbie
  • *
  • Posts: 1
Re: Erase-It
« Reply #39 on: November 07, 2003, 12:35:48 AM »
by far i feel this is the best storm ball to date for what i have used the ball has a very even roll the x-factor is similar but can be be spotty a very good ball for the low rev bowler or the high rev bowlers which determines whether or not to leave dull or polished this is my number 1 ball

razman

  • Jr. Member
  • **
  • Posts: 10
Re: Erase-It
« Reply #40 on: December 09, 2003, 05:03:00 PM »
by far the best storm I own.I got the ball weighting 15.8 now weights 15.6. I am 14 and i have shot consestent 200-240's with it. It rolls great has a lot of backend. It hits hard but I have trouble with carrying 10 pins with the ball. Overall great ball.    pin directly above the fingers.  

                         o
                        0 0
   

                         0

razman

  • Jr. Member
  • **
  • Posts: 10
Re: Erase-It
« Reply #41 on: December 09, 2003, 05:05:48 PM »
sorry pin placement is wrong on the little drawing


                             o
                            0 0  


                             0

razman

  • Jr. Member
  • **
  • Posts: 10
Re: Erase-It
« Reply #42 on: December 09, 2003, 05:06:55 PM »
placement is directly above the fingers not on the left

stormrocks

  • Newbie
  • *
  • Posts: 2
Re: Erase-It
« Reply #43 on: January 02, 2004, 01:21:26 AM »
this ball was a good one for me and the ball ges don the alley and when it hits the pins they go in the pit, al ten of them. the oin placement 2.5 - 3 with 2.5 ounces of top weight. Drilled with #2storm drill

Soonermike

  • Jr. Member
  • **
  • Posts: 20
Re: Erase-It
« Reply #44 on: January 13, 2004, 12:08:57 PM »
I've had this ball over a year and thought it was time for a review.  I got this ball from Doug Sterner and left the drilling alone.  I don't know the exact drill, but the pin is right of fingers about 2 inches and the cg is swung towards the palm.

This ball is the ball I use when the lanes are a bit tight or I'm struggling.  I can always get it to the pocket.  I don't like it when people say that whatever ball they are reviewing is a great ball, because most are on the right condition, but bottom line is that this ball is versatile.  

Although I usually score better with other balls when conditions are right for them, but with the Erase-it, I can find a good line in about everything but very dry heads or heavy oil shots.  A great ball for anyone that sees a lot of medium conditions.
--------------------
SoonerMike
SoonerMike

SkillzMagillz

  • Newbie
  • *
  • Posts: 4
Re: Erase-It
« Reply #45 on: December 08, 2004, 12:10:31 PM »
I've had this since it came out.  I was 16 and I shot 690 my first series with it.    It's only got better since then.  I drilled it to go long with a hard snap that I could use on heavier conditions.  It had a really great move to the pocket.  I usually stand about 10 past center and throw it to 2-4 (in that area).  It rolls really smooth but I would not use it on wood.  Like most storm balls, I feel they should be used on synthetic only,  this one does just the same.  I used it on wood for 2 years and got an extremely inconsistent reaction.  But on synthetic...you can't get anything better.