Author Topic: Balance hole on Virtual last option? (Read 4195 times)

LaneHammer20 · « **on:** February 17, 2009, 01:49:29 PM »

Well once again after more surface changes, the ball still is just not strong enough. It's length is just to long, it is effotless length like a pearl ball, wants to move hard in the back, but on oil is is normally to late, and with all the length is a over under reaction.

Last week I went to 1500 abralon, still to long, better than OOB, but still to long. Tongiht had it at 1000 abralon, and although better, still would leave me washout's if I wasn't spot on. Definitly had to keep my speed in check, to make sure it didn't go past the break point. Wish I would have brought my pin down Dimension at same surface to compare.

I am going to league at the house my driller owns. Am wanting to put a balance hole in it, to see if it helps get some better midlane. Anybody got some suggestions, I am not going to redrill, would probably sell it. Hoping a balance hole will help. Anyone?
--------------------
What is sandbagging???

Z Jellsey · « **Reply #31 on:** February 20, 2009, 12:20:24 PM »

The best way I can describe it, was told to me the other day in relation to a customer asking about a Track ball(Rising SE).

The customer was worried about the chosen layout due to excess thumb weight. "The core in that ball weighs over 7 lbs. Do you really think a 1/2 oz here or there is going to affect a 7+ pound core?" It appeared very clear to the customer and myself after hearing that.

--------------------
Honor Scores: ?

Author Topic: Balance hole on Virtual last option? (Read 4195 times)

LaneHammer20

Balance hole on Virtual last option?

Z Jellsey

Re: Balance hole on Virtual last option?